What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
11.06.2025 13:06
For this case there are devices called Metal oxide varistors (MOV).
the problem then depends on "how fast does the fuse operate?".
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
What’s the craziest thing you’ve heard pretending to be asleep?
Because the load is inductive, the current lags the voltage.(by a bit).
So, the voltage could go up to 500 volts, and the fuse will not open up.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
What is the worst emotional pain you ever felt as an adult?
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The third is lightning and “how it gets conducted into a home.”
What we learned from the 2025 Le Mans 24 Hours test day - The Race
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
so, what happens?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At one ohm, the resistor has a maximum of 1 watt power.
The bolt then partially travels down the line to your home.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–14 [Omar Gharbi Omar Gharbi ]
In schematic diagrams this is the symbol for a fuse:
[old diagram got deleted by accident]
But… the neutral is now “floating” because of the 1 ohm resistance.
This is 'the assistant's answer'
The MOV will conduct when the voltage exceeds 50% of line voltage.
Can you share any "backstage pass" experiences you have had at concerts?
It also is a device that limits the change in current flow.
Upvotes:
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
2024–10–16 [ OO OLAOYE OYEBODE ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
But it can get overloaded, and no longer works.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
He then describes Rainy Season and Lightning.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
At least they know the answer if they wanted it.
Here is a simplified AC power diagram.
He then describes the function of a fuse.
2024–10–10[John johnson John Johnson ]
but this device (an Inductor) … impedes the rapid changes in the current.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
nine
A fuse is a non-resetable over current circuit protector.
I post the exact comment here.
There are three different concepts here that are getting confused.
but I think this circuit , shows a few more pieces.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
a photo is worth a thousand words.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Edit 2024–10.
It seems Mohan does not understand the difference between a comment and an Answer.
There are two important concepts here.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
One
The other is “what does a “fuse” do?”
These devices are installed between the “hot” and “neutral” and protective ground.
(Dc diagram shown, AC is similar).
A circuit breaker is similar, but is resettable.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Now when you have a certain ac resistance, then a current flows in a loop.
He then asserts :
First Sentence:
eight
One is “what exactly is in a ‘surge protector’ ? ”
This is where this question deviates from being a 'generic' question, and becomes more specific.
What does a fuse do?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is where the MOV conducts again, and dissipated the energy.
These are simplified answers to the original question, and does not change anything I wrote above.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Barnstars:
This one hit behind the barn.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
[image of Common-mode choke]
This device then solves the entire problem.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
An AC voltage/ current source, and an ac inductive load.
What is lightning?
what exactly is a ‘surge’ protector?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.